Proline T3000 Operations Instructions

$15.00OPERATION & MAINTENANCEMANUALIMPORTANT: CAUTION! TO REDUCE RISK ORINJURY, READ OPERATING INSTRUCTIONSCAREFULLY BEFORE USINGCP SERIESHD SE

10 SYSTEM INFORMATIONThe FUEL SOLENOID is an electric fuel valve which shuts offthe fuel whenever the trigger on the spray gun is released or

SYSTEM INFORMATION 11HYDRO TWISTER (OPTIONAL)The Hydro Twister is a surface cleaner thatconnects t

12 TROUBLE SHOOTING GUIDEPROBLEM PROBABLE CAUSE* REMEDYCharge or replace battery, add electrolyte ifbattery is new.Clean connections.Connect or re

REMEDYPROBABLE CAUSE*Check-valve in the strainer clogged.Chemical valve not open or clogged.Strainer not submerged in solution.Detergent hose cut or k

14 120VAC BURNER TROUBLE SHOOTING FLOW CHARTIS THERE DIESEL FUELIN THE TANK?IS THE THERMAL O/L ONTHE BURNER MOTOR ORTHE BREAKER TR

12VDC BURNER TROUBLE SHOOTING FLOW CHART 15IS THERE DIESEL FUELIN THE TANK?IS THE BREAKER ONTHE CONTROL PANELTRIPPED OR IS THEINL

WIRING DIAGRAMS HD 16

17WIRING DIAGRAMS HG

WIRING DIAGRAMS HP 18

19WIRING DIAGRAMS SS

TUR BO NOZZLEADJUSTABLE PRESSURE WANDCHEMICAL IN JECTORSSAND BLASTERHOSE EXTENTIONSHOSE REELS WASH WATER RECYCLE / RECOVERY / FILTRATIONThe ANT38 HYDR

20WIRING DIAGRAM SC / SS

21WIRING DIAGRAMS SM

22WIRING DIAGRAM SR / ST

SERVICE RECORD 23 MODEL#_______SERIAL# __________Date of ServiceMo./Day/YearNumber of Run Hrs.Since Last ServiceService Performed

MAINTENANCE INFORMATION24equipment. Contact your Hydro Tek dealer for mainte-nance. A small investment in preventative maintenance willadd many h

TABLE OF CONTENTS 3INTRODUCTION ...

4 INTRODUCTIONINTRODUCTION:THANK YOU: The employees and management

IMPORTANT SAFETY WARNINGS: SAVE THESE INSTRUCTIONS 5use gasoline. Do not confuse gasoline and fuel oil tanks. Keep properfuel in proper tank.3. NEV

BEFORE START UP:1. Read all instructions before using this product.2. CHECK OIL AND FLUID LEVELS:Check pump oil by locating the oil view window ordips

SHUT DOWN / SYSTEM INFORMATION 77. SET CHEMICAL INJECTION: If unit is equipped with inletchemical injection, place chemical pickup tube in pre-mi

8 SYSTEM INFORMATION Do not rely on the low oil shutdown (if equipped) as areminder to add oil. Engine damage from lack of oil willtypically no

will apply chemicals only at low pressure. If equipped standardwith downstream injection, adjust concentration level by turn-ing brass collar on the